Shindaiwa EB8520RT Manual do Operador Página 29

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 136
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 28
27
Maintenance and care
Additional problems
Diagnosis Cause Solution
Poor acceleration. Clogged air filter. Clean the air filter.
Clogged fuel filter. Replace the fuel filter.
Lean fuel/air mixture. Consult your shindaiwa dealer.
Idle speed set too low. Adjust 2000 (±200) r/min.
Engine stops abruptly. Ignition switch turned off. Reset the switch and restart.
Fuel tank empty. Refuel.
Clogged fuel filter. Replace fuel filter.
Water in the fuel. Drain; replace with clean fuel.
Shorted spark plug or loose
terminal.
Clean or replace spark plug, tight-
en the terminal.
Ignition failure. Replace the ignition unit.
Piston seizure. Consult your shindaiwa dealer.
Engine difficult to shut off. Ground (stop) wire is discon-
nected, or switch is defective.
Test and replace as required.
Overheating due to incorrect
spark plug.
Idle engine until cool. Clean and
regap the plug to 0.6 mm. Correct
plug: NGK CMR5H or equivalent
resistor type spark plug of the cor-
rect range.
Overheated engine. Idle engine until cool.
Excessive vibration. Debris build-up in impeller. Clean debris from impeller as re-
quired.
Loose or damaged impeller. Inspect and replace impeller as re-
quired.
Loose or damaged engine
mounts.
Tighten or replace engine mounts
as required.
Engine overspeeding. Blower intake or discharge
ports or tubes are clogged with
debris.
Inspect and remove debris.
Impeller blades are missing or
damaged.
Consult your shindaiwa dealer.
Checking and maintenance requires specialist knowledge. If you are unable to check and maintain the product or deal with a
fault yourself, consult your shindaiwa dealer. Do not attempt to dismantle the product.
Consult your shindaiwa dealer in the event of a problem that is not covered in the table above, or other such concerns.
For spare parts and consumables, please use only genuine parts and designated products and components. Using parts from
other manufacturers or non-designated components may result in a malfunction.
Vista de página 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 135 136

Comentários a estes Manuais

Sem comentários